See our How To Order page for instructions. Discreet import engraving.įFL is required for delivery. Light gouging on the left side on the thumb rest. Wood grip has light gouging on the right side at the bottom. Light pitting and light scratches on the underside of the barrel. Light scratches at the end of the barrel. On the left side, there are light surface marks on the bolt knob and rear of the receiver. Light surface marks on the edge of the barrel rib. On the right side, there is heavy patina on the bolt removal pin. After that, it is recommended the screw is turned another 90 degrees to achieve both shortest trigger pull length as well as reliable operation of the trigger.Czechoslovakia-made Drulov model 70 single shot, bolt action, rimfire target pistol. An audible click indicates the trigger has engaged the matching part of the trigger assembly.Turn the trigger pull length adjustment screw, screw 10, clockwise to reduce, the reverse to increase. Turn screw 11, the trigger stop screw, clockwise to reduce the play after discharde and the reverse to increse the play. The trigger stop and trigger pull are controlled by the two screws (10 and 11) located behind the trigger.In this case, turn the screw (9) clockwise until reliable functioning is restored. If you try to set the trigger pull too low, the trigger will frequently remain stuck in the rear most position after discharge. Never apply force when making adjustments. Turn it clockwise to increase, the reverse to decrease. The screw located in front of the trigger guard serves to adjust the trigger pull from 3N to 7N.The trigger position may be adjusted whithin a range of 8mm by releasing the screw (12) and shifting the trigger into a convenient position. The trigger is fitted on to the devetailed trigger bar.A 12g CO2 bulb should contain enough propellant gas for about 70 discharges if the muzzle velocity is set at the optimum level of 311-377 fps.Turn the nut clockwise to increase the muzzle velocity, counter-clockwise to reduce.by turning the slotted nut (3) which is located below the muzzle. The velocity may be adjusted from 262fps to 410 fps.Turning the screw head by one click shifts the point of impact by 3mm at 10 meters. The letters engraved on top of the assembly indicate the direction of adjustment.The rear sight leaf may be laterally or vertically adjusted by turning the serrated screw hands (6 and 7) located on the right and left hand sife of the rear sight assembly.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |